Siebel Administration > SBL-SMI-00001: Invalid parameter
SBL-SMI-00001: Invalid parameter
The above error by itself does not provide sufficient context to troubleshoot the issue. It is usually accompanied by additional error message(s) that offer more insight as to the cause for failure. For example, in the case mentioned below the error was reported alongside the SVR-04022 error.
SVR-04022: Host not enabled SMI-00001: Invalid parameter
Cause
Since this is a generic message, it is/are the accompanying error messages that provide for necessary troubleshooting information. In the case above, the customer had Resonate installed in their environment. SVR 04022 usually indicate issues with the resonate installation/configuration.
Diagnostic Steps
Use the additional error message to build sufficient context and know-how about where and for what reasons the error is being reported.
Solution
Specific solutions are not applicable since it is a generic message by itself. Looking up the additional error message(s) and follow the suggestions/recommendations outlined for them to further troubleshoot the problem at hand.
|